Hula Hoop Rug Craft

Materials: Scissors, About a dozen T-shirts, 33-inch hula hoop
 
 
 
 
 
 
 
 
 
Instructions:
  1. null
    For the warp, cut 1-inch-wide loops from the bodies of one or two tees (we found
    a boy’s large worked best on our 33-inch hoop), removing the hem and stopping at
    the sleeves. Ideally these loops should all be the same color; we used two
    colors for clarity in our photographs. You’ll need a total of 11 loops. For the
    weft, cut at least 50 loops from the remaining shirts. Save the unused sleeves
    for the basket project.
  2. null
    Stretch one warp loop over the hula hoop, as shown.
  3. Step 3
    Add and secure a second loop, perpendicular to the first.
  4. null
    Repeat, filling in the spaces, until all 11 loops are in place.
  5. null
    Push together two warp loops at the top of the hula hoop, as shown. This creates
    an odd number of warp spokes in your wheel, which allows the overunder pattern
    of the weft to alternate with each new row.
  6. Step 6
    Secure the first weft loop to the center of one of the warp spokes (we chose the
    doubled spoke from step 5) by wrapping it around the warp and then looping it
    back through itself.
  7. null
    Begin weaving the weft over and under the warp spokes, forming a tight spiral.
    For now, treat both parts of each warp spoke as a single unit, weaving over or
    under the two together. As you work, push the weft material toward the center of
    the hoop and keep it just snug. If you pull the weft tight, the rug will develop
    lumps or bends. When you reach the end of the piece of weft, add a new loop by
    threading it through the end of the first and back through itself.
  8. null
    When your rug is about 8 inches across, begin treating each warp spoke as two
    individual strips instead of a single unit, weaving over or under each strand
    instead of going over or under the doubled spoke. This increases the number of
    warp spokes, improving the structure of the project. When you get to the two
    warp spokes that you pushed together at the top of the loom, separate them.
    Treat one of the spokes as two individual strips, but continue to treat the
    other as a single spoke. This maintains the odd number of warp spokes.
  9. null
    When the rug is the size you want, but no closer than 8 inches from the edge of
    the hula hoop, snip open your weft loop.
  10. null
    Tie the ends around a warp spoke, and tuck the ends into the rug.
  11. null
    Cut the warp spokes off the hoop one at a time.
  12. null
    Tie the ends in pairs, then trim them to make a fringe or tuck them back into
    the rug.
From: www.familyfun.com
 
++++++

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s